Clip Automation - volume point adjustments.

[Big Jim]

Hi,  Does anyone here know an easier way to adjust the actual db point value on a track?  I can click on where I need the adjustment to start and finish, but I can oly do this with the mouse + or -  and, while large volume/value changes can be easy with the mouse micro adjustments  + or - 1 or 2 points is extremely frustrating as the red line snaps back to the 0 point line.  Is there some way to "type in" or fine tune the db value on a point in a track without having to fight with the mouse?

Thanks

[DannR]

Unfortunately, the only option to move the DB is using the mouse. NCH Software formally takes suggestions or feedback about our products through the form at http://www.nch.com.au/suggestions/
 

[fikeypod]

Hi Big Jim,

I've just logged this as a suggestion to NCH as I've been having the same frustrating problem. Even if it the fix was something as simple as holding down the control key as you move the fade point that stops it from 'snapping to'. Fingers crossed this gets updated.