axon and italk in NZ

[johnm]

Has anyone got axon working with italk (voip service provider in NZ)

 

I have multiple pap2t boxes working perfectly with italk. Both akl and hlz servers.

I can also get pap2t boxes going ok as extensions to Axon.

However i can not get Axon to send calls to italk.

Seems to accept inbound calls from italk OK but have not fully tested that.

 

When sending a call from pap2t via axon to italk i get a "488 not acceptable here" error code even tho the same box connects ok to italk directly.

[pythonpoole]

Have you setup an appropriate dialing plan in Axon? Perhaps it is trying to dial on the wrong line, or the number that is 'dialed' is modified and is not been sent to italk as it was intended. I'll have to look into what exactly the causes for an error 488 can be, but I think it could also be a Codec problem if you're sure your dialing plan is set-up right.

[johnm]

Have you setup an appropriate dialing plan in Axon? Perhaps it is trying to dial on the wrong line, or the number that is 'dialed' is modified and is not been sent to italk as it was intended. I'll have to look into what exactly the causes for an error 488 can be, but I think it could also be a Codec problem if you're sure your dialing plan is set-up right.

 

I believe the calling plan is correct. Watching the log shows things are the way i expect. It is accepting inbound sort of ok so correct authentication seems to be in place.

Tried different codecs but of course with express talk there is no way to change it if using that for a "temp" phone for testing

John