There is no input signal on recording

[Sounder]

I can't configure WavePad to accept and record input signals. After a long and futile effort to solve it I go to the Technical Editor Support page. It looks like I have my answer right there in the General Support Questions / There is no input signal on recording and nothing is recorded. Exactly right! I follow all the instructions concerning the Windows Audio Controls setup, that is a well documented process. Everything is set up as required by Windows. But the very last step 3. NCH Recording Settings. Access to this WavePad specific item is not publicized! Where can I find the NCH Recording Settings form with its Record tab, to select the proper Recording Device AND Input Channel. I do not know if that solves my problem, but it is nowhere to be found!

 

My microphone is just fine, loud and clear. I can load and play music files, no problem. But I can not get the my Line-2/Mic 2 input of my Soundblaster Audigy Platinum eX card to record. That channel is selected both for Play Control and for Recording Control in the Windows Audio setup mixer. A little advice would be greatly appreciated.

[rrrobinsonjr]

This is basically the same issue I'm having.