Problem with Pocket Talk v1.01

[DooMaster]

Well, I config the Pocket Talk v1.01 on mi iPAQ rx3115 with Windows Mobile 2003 SE and the SIP provider sip.voipraider.com. Everything is fine, the audio wizard goes correctly (the mic and speaker), but the network complains about the NAT, complaining about possible performance problems.

 

When I make the call, the other phone answer and connect, but there is no audio in and out, in both the phone and the iPAQ. I can see on my iPAQ the mic meter working (so it seems that the mic is receiving audio). When I hang up, the call ends, i wait so far 30 seconds and there is no audio.

 

This is all about the Router? I was using a Thomson STB585 v6 Router/Modem, I have to open the ports? I want to be pretty sure about what is the problem.

 

I like the program very much, so I want to work on this, if someone can help me I'll be so grateful, and if someone whants to experiment, VOIPraider gives 1 minute free call on any international call.

 

Best regards, and congrats for the software.

[nanocom]

Well, I config the Pocket Talk v1.01 on mi iPAQ rx3115 with Windows Mobile 2003 SE and the SIP provider sip.voipraider.com. Everything is fine, the audio wizard goes correctly (the mic and speaker), but the network complains about the NAT, complaining about possible performance problems.

 

When I make the call, the other phone answer and connect, but there is no audio in and out, in both the phone and the iPAQ. I can see on my iPAQ the mic meter working (so it seems that the mic is receiving audio). When I hang up, the call ends, i wait so far 30 seconds and there is no audio.

 

This is all about the Router? I was using a Thomson STB585 v6 Router/Modem, I have to open the ports? I want to be pretty sure about what is the problem.

 

I like the program very much, so I want to work on this, if someone can help me I'll be so grateful, and if someone whants to experiment, VOIPraider gives 1 minute free call on any international call.

 

Best regards, and congrats for the software.

 

I have the same exact problem :'( I also have ports 5000-5071 UDP/TCP open and 8000-8110 UDP/TCP open... so it can't be those ports... maybe other ports.. maybe some config issue.. beats me!

 

I can attest that it worked once for me, didnt change config after it started working, and it immidietly stopped working thereafter.

 

What I changed for this one incident is call quality in sound setup. I used lowest quality. It worked perfect for the call i initiated right after. The call right after that one didnt produce any sound or send any sound even though the sound bars were going up as people were talking. Doesn't work until today. Sad story.. someone give us a happy ending please!!!

 

 

Thanks