Jump to content

Axon & Sipura 3102


Recommended Posts

Hello,

 

I am Zafar Jadoon from Pakistan. I am using Axon with X-Lite and Sipura 3102 without using Gateway (not using any service providers) with in a campus. I need to connect Axon to our physical exchange estensions. my Axon is working properly but when I try to connect my X-Lite to hard phone (physical exchange) it just give me a one ring and than disconnect. I dont need to connect out side the campus. I just need to connect my soft phone to physical phone extensions and physical extensions to soft phone through Axon. Any body who can help me out to this kindly send me the configuration of Axon Dial Plan, External Line Setting and Sipura 3102 settings.

 

we are using 172.16.4.0 255.255.252.0 Ip scheme in our campus and Axon is properly working in same environment and want to use sipura fixed ip address from same settings.

 

kindly any body who can help me send me the mail with above mentioned setting to

 

zkjadoons@msn.com or zkjadoons@gmail.com

 

I already post three time but nobody response me kindly help me out from this situation.

Link to post
Share on other sites

Have you followed the instructions/guides for setting up the SPA-3102 with Axon?

 

I have written one of the guides (check the pinned topics in this forum), and there is also one by NCH. If you have successfully setup the FXO adapter as described in these guides, you should have the ability to

1) Accept incoming calls from a physical exchange connected to the 3102 Adapter

2) Make outgoing calls to a physical line (same as above) connected to the 3102 adapter

 

In terms of the dialing plans, just make sure the default line is set to the FXO line you setup while configuring your 3102 adapter earlier.

 

After this is done all calls made from a softphone registered with Axon with that dialing plan should automatically attempt to go through the physical line attached to the 3102 adapter, and all incoming calls should be forwarded on to the appropriate softphone extensions as set in the line's properties.

 

If you have any further questions or problems, don't hesitate to ask. Please include your SPA-3102 and Axon configuration if possible. (SPA configuration can by opening the config page in a browser and saving the webpage (it will automatically save all tabs), Axon configuration can be saved using the backup-feature in the main window).

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...