Specify wall length in free draw

[JoeDMart]

Is there a way to specify the length of a particular wall in free draw?

[Jsalgado]

Left click on the desired starting location. Drag the mouse to the desired end point and left-click again to complete the wall. The length of the wall is displayed on the property panel.

[JoeDMart]

Thanks, but I want to specify the length of a wall to the nearest fraction of an inch. This is very difficult to do by dragging the mouse to locate the ending point of the wall. Thanks for your help.

[krishnamoorthy]

On 6/11/2020 at 1:34 AM, TECH Support said:

Left click on the desired starting location. Drag the mouse to the desired end point and left-click again to complete the wall. The length of the wall is displayed on the property panel.

but after feet inches not showing if we need exactly 5 feet 7 inches, we cant do in free wall draw

[krishnamoorthy]

On 6/11/2020 at 4:24 AM, JoeDMart said:

Thanks, but I want to specify the length of a wall to the nearest fraction of an inch. This is very difficult to do by dragging the mouse to locate the ending point of the wall. Thanks for your help.

yes i feel same problem

[Chris75]

Hello, 

limiting the length of the wall will beat the whole purpose of free drawing.  If you want to create a wall with specific length then you would need to use the fixed drawing option.

[krishnamoorthy]

Hello sir, I too accept your thoughts but

During free wall drawing it's resolution is 1 feet instead program such a way that is between feet divide by 12 inches so that 1 feet after 1'.1", 1'.2" etc upto 1'.11" then let jump to 2 feet that will solve our problems