Search the Community
Showing results for tags 'sync issues'.
Sound and waveform not synchronized Quite disabling to my work. On the sound tract that reads: ". . epidermis is the outer layer of skin that overlies that deeper layer of skin . ." The whole word "epidermis" is heard BEFORE its waveform begins. The video has been edited with a number of splitting, deletion and speed change. The asynchrony cannot be a hardware or driver problem because if the video (exported from VideoPad) is played in WAVEPAD, the sound and waveform are perfectly synchronized. Also, playing back the same original wmv file in VideoPad without any editing (splitting etc), the sound and waveform are also well synchronized. WH Kwong
I've just downloaded, installed (and paid) for the latest VideoPad as my previous registered version was going all the way back to 3.7 or something and missing a lot of features. Its been difficult to get accustomed to the colour and layout change, but they are gradually becoming manageable. What is not workable though is the sound syncing. It lags! Its nearly impossible to place audio where I want it (by ear) when adding extra sounds as they do not sound correctly in the preview. I can visually line the waveform up with where I want it to sound, but unless I press play preview from that point its completely out of sync when starting the preview from the beginning of the whole sequence or even just seconds prior. The same goes for audio attached to the video on import - it lags and gets worse the longer you watch the preview clip for. However when I export the video and watch back on my PC/Phone whatever, its all good and where it should be. I got so frustrated I even rolled back to my version 3 where this issue does not exist, but then nor do the features I require! Any help resolving this would be appreciated as its just unusable and I really want to stick with this version. On a side note that I have put up with for years, WavePad editor does a very similar thing, whereby the visual representation of the waveform does not comply with where the red line shows it to be playing! I've managed to get by as am normally just trimming silences of the start and finish, but on the rare occasion I do need to watch and listen to the waveform, there is no correlation between the two and its all pot luck. The issues must surely be related? TIA
I have synced my item list from Inventoria into Copper, but all of the items in Copper say default tax rate. In Inventoria the items have the correct tax rates. Is there a way to fix this issues. All back-end work is being done in inventoria. Copper is only for point of sale. I don't want to have to change all of our tax rates again.