Jump to content

How to add Transition


RizMan

Recommended Posts

Hi Rizman

Also not quite sure what you mean by "Less than 1-2 min"  and "auto-populate" However switch the timeline into Storyboard mode and check that you don't have a blank "frame" where you have split the clip and want to add the transition. (There would be no "X" in any case.) It's just a thought. There were some reports in earlier VP versions that a split caused a tiny gap in the project that was unnoticeable at normal zoom levels.

Are you overlapping the clips or choosing to add a still frame?  Obviously overlapping means that there must be adequate final clip length to accommodate the length of the transition.

Could you clarify the problem.

Nat

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...