Saros Posted August 21, 2019 Share Posted August 21, 2019 Is there any way to "Turn Off" the auto selection of the connector points when you move over an object. In other words only create connectors when the connector tool is selected. When trying to layout charts, move (drag) objects or move the centre point of a connector line it can get very difficult and frustrating that a new connector is started. Being able to turn this off so it doesn't start a new connector would make layout a lot less frustrating. Link to comment Share on other sites More sharing options...
DannR Posted August 21, 2019 Share Posted August 21, 2019 That would be the only option, unfortunately the program doesn't have the option to turn it off. NCH Software formally takes suggestions or feedback about our products through the form at http://www.nch.com.au/suggestions/ Link to comment Share on other sites More sharing options...
chichigo Posted February 10, 2020 Share Posted February 10, 2020 I think it is possible by clicking turn off highlighting connection point option at the bottom right, just above the zoom controls. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now