Jump to content
vroberts

Connector with one 90 degree bend

Recommended Posts

How do I make a connector with one 90 deg bend? If I start with the orthogonal connector with two bends, I can sometimes change the legs to get rid of one bend, but the size of the legs is limited.  Other times I can get rid of one bend, but the arrow at the end is turned 90 degrees. I need a connector that starts out horizontal, and then turns down to meet with another element.

Share this post


Link to post
Share on other sites

I have more information about my problem. I see that the connector is supposed to adjust automatically as the end is brought near the destination shape. This does not work correctly on my 4k display that is set for 250% display magnification.   However, it dose seem to work on a lower resolution display, so the problem may be limited to high resolution displays, and perhaps only at high magnification. I will test this further.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...