paperworks

Rob, I purchased the same SHT-2B/USB from alto edge. I went to manufactures web site to find the correct driver. Everything I did failed. I got the email below from the manufacturer last Thursday. I then downloaded the correct driver and it works perfect. It is Sophia from Synway technical support. Regarding the problem with USB board instillation, I would appreciate if you could provide me with the following information. 1. Which country and company you are in, and who/where you purchased the board from? 2. Which driver version you have used to install your board? 3. Which operating system you install this board on? If you install the board on operating system Vista, Please check out the ‘ Memo of USB installation under Vista’ under ShCti 4.7.3.1.1 at http://www.synway.net/support/Driver_download.asp If the operating system is not Vista, follow the steps below. 1. Shut down the computer 2. Plug the board to another USB slot properly. 3. Start your computer 4. Uninstall the Synway driver 5. Re-install the driver (if you have just purchased the board, you can also obtain the Synway driver from above link for latest version ShCti4.7.3.1.1 (for PCI). If the board is still unable to be installed after you have done above installation. I also can provide you with on site help. For easy and instant communication, I am wondering if you have a hotmail live messenger. If you have it, please add me in or give me your hotmail address. I look forward to hearing from you. (OA: SHG070828003) Best Regards, Sophia Dong Synway Information Engineering Co., Ltd Tel: 0086-571-8886-1158 ext.:2010 Email: dyt@sanhuid.com Msn: sophia-synway@hotmail.com http://www.synway.net

I am using "!," for a flash transfer with the "," as the delay. Regardless of what I do, the addplication log does not show the "," being dialed for a delay. The log shows the "!" only. how do I get the application or hardware to recognize the "," for a delay?