End point at timeline is wrong

[Wavy77]

I made a film that lasted about 40 minutes. During editing I noticed that around 32 minutes "Place on sequence at end" option put the clip at the same spot every time, even after that spot is not at end. I didnt think much about it until I exported the video but then noticed that what the program defined as the end point in fact became the end point of the film, meaning the last 10 minutes were simply left out. Now I try to edit it again, the "Place on sequence at end" option constantly end up at the same point, even if I remove all the clips at that point (if a corrupted clip was the problem).

 

Has anybody encountered this before?

 

Sorry, found out now that you can actually move the out point. Never saw that one before